Testing Board Requirements

Sensor Requirements

The following sensors should exist on the board.

• Accelerometer
• Gyroscope
• Magnetometer
• Temperature sensor (digital)
• Thermistor
• Barometer

There shall be at least one sensor that is used for SPI AND I2C.

Each sensor shall be broken out into their own respective connectors.

Other ICs

There must be a GPS receiver module that can be added to the board.

There must be a CAN bus transceiver. This must be broken out into a connector.

Microcontroller must be broken out for the programming connector.

Microcontroller should have two LEDs connected to two seperate GPIO pins.

System Requirements

• All devices run on 3.3V
• Decoupling capacitor on all devices
• ESD protected
• 4 layer board (signal, ground, power, signal)
• All devices must have a datasheet
• Have an LED power indicator

Purchasing Requirements

• Entire bill of materials should be under 50 dollars (not including PCB or shipping or 0603 components already in inventory)

Layout Requirements

• The placement of switches shall be organized and sectioned for each sensor
• The text overlay on the board shall clearly communicate the function of each set of switches